Land Pride Indoor Furnishings DP25 User Manual

Post Hole Digger Storage Stand  
Assembly Instructions  
For PD10, PD15, PD25 & PD35 Post Hole Diggers  
Manual No. 317-189M  
20856  
20776  
PD10 Storage Stand  
Figure 1  
PD15, 25, and 35 Storage Stand  
Figure 2  
Before You Start  
General Information  
These assembly instructions apply to the following  
Storage Stand Accessories listed below:  
When you see this symbol, the subsequent  
instructions and warnings are serious - follow  
them without exception. Your life and the lives of  
others depend on it!  
!
317-166A  
317-142A  
PD10 Storage Stand  
PD15, PD25, & PD35 Storage Stand  
Tools required:  
IMPORTANT: Before you begin, read these  
instructions and check to be sure all parts and tools  
are accounted for. Please retain these installation  
instructions for future reference and parts ordering  
information.  
Safety glasses  
Work gloves  
Two 9/16" box end or open end wrenches  
Two 3/4" box end or open end wrenches  
Your Storage Stand is exclusively designed for your  
Land Pride PD10, PD15, DP25 & PD35 Post Hole  
Diggers. Please read these installation instructions and  
your Post Hole Digger Operator’s Manual thoroughly  
before beginning. Especially read information relating to  
safety concerns. Also included in the Operator’s Manual  
is important information on operation, adjustment,  
troubleshooting, and maintenance for this attachment  
(some manual sections do not apply to all accessories).  
Further Assistance  
Your dealer wants you to be satisfied with your new  
Mower Jack. If for any reason you do not understand any  
part of this manual or are not satisfied with the service  
received, the following actions are suggested:  
1. Discuss the matter with your dealership service  
manager. Make sure he has had time to assist you.  
2. If you are still not satisfied, seek out the owner or  
general manager and explain the problem.  
A separate Parts Manual for your digger is available free  
from your nearest Land Pride dealer. Have the model  
and serial number of your Storage Stand handy when  
placing an order.  
3. For further assistance write to:  
Land Pride Service Department  
1525 East North Street  
P.O. Box 5060  
Manual Part Numbers:  
Operator’s Manual . . . . . . . . . . . . . . . . 317-048M  
Salina, Ks. 67402-5060  
Parts Manual . . . . . . . . . . . . . . . . . . . . . 317-048P  
E-mail address  
© Copyright 2008  
Printed  
10/06/08  
 
1
Land Pride  
Listing of Parts  
Kit No. 317-166A  
PD10 Storage Stand Assembly  
Item  
Part No.  
Part Description  
Qty  
1
2
3
4
5
6
7
8
9
317-166A  
317-148H  
317-164H  
317-165H  
317-167B  
802-034C  
803-147C  
817-455C  
838-298C  
PD10 STAND ASSEMBLY  
PD STAND HITCH WELDMENT  
PD10 STAND CRADLE WELDMENT  
PD10 STAND WELDMENT  
PD10 STAND HARDWARE BAG  
HHCS 1/2-13X1 1/4 GR5  
NUT HEX NYLOCK 1/2-13  
KNOB 1/2-13 MALE THD 2 3/8OD  
DECAL CAUTION DO NOT LEAN ON  
2
1
1
1
2
2
2
2
10/06/08  
Post Hole Digger Storage Stand Assembly Instructions Manual No. 317-189M  
 
3
Land Pride  
PD15, PD25, & PD35 Assembly  
PD15, PD25, & PD35 Assembly  
NOTE: Do not disconnect Post Hole Digger from a  
tractor on a steep slope. Injury to personnel and  
equipment may result.  
Part No. 317-142A  
A detailed listing of parts for this accessory kit is  
provided on page 5. Use the list as a checklist to  
inventory parts received. Please contact your local  
Land Pride dealer for any missing hardware.  
Attach storage stand (#4) to cradle (#5).  
1. Make certain guide slots (#2) at end of storage stand are  
securely positioned over cradle pins (#3). Secure  
storage stand to cradle with clamping knobs (#11).  
Refer to Figure 2 on page 1:  
2. Without starting the tractor, lower boom (#14) to rest  
yoke hitch pins securely in support angles on the storage  
stand. Some adjustment to the support angles may be  
required.  
The optional storage stand may be used when the  
PD15, PD25, and PD35 Post Hole Digger is not in  
operation. It will help prolong digger’s life by keeping  
the unit off the ground where moisture and debris are  
more likely to collect causing undue damage to the  
digger. Also, the storage stand design aids in  
mounting and dismounting the Post Hole Digger to  
and from the tractor.  
3. Disconnect 3-point hitch.  
4. Start tractor and drive away being careful not to catch on  
the Post Hole Digger and Storage Stand.  
PD15, 25, & 35 Storage Stand  
Assembly  
Refer to Figure 4:  
The Storage Stand Assembly consists of an A-frame  
storage stand (#4), clamping knobs (#11), cradle  
(#5), and a bag of (4) - 3/8”-16 x 1” long GR5 bolts:  
1. Unscrew locknuts (#8) and remove  
1/2"-13 x 3 1/2" GR5 hex head bolts (#7). Slide  
auger (#13) off of gearbox output shaft.  
2. Remove existing hex head cap screws (#6),  
lockwashers (#10) and flat washers (#9) from  
underside of gearbox. Remove auger guard (#1).  
3. Position cradle (#5) between auger guard (#1)  
and gearbox (#12). Make sure cradle pins (#3)  
are positioned to the back as shown.  
4. Use four new hex head bolts (#6), lock  
washers (#10) and flat washers (#9) in hardware  
bag to attach cradle (#5) and existing guard (#1)  
to gearbox (#12).  
5. Reattach auger to gearbox output shaft with  
existing auger bolts (#7) and locknuts (#8).  
PD15, 25, & 35 Storage Stand  
Operation  
Refer to Figure 4:  
Lower auger tip to the ground at the location you plan  
to disconnect the Post Hole Digger from the tractor.  
Set tractor park brakes, turn tractor engine off, and  
remove ignition key before dismounting tractor.  
Always chock tractor wheels for an extra measure of  
safety if you stop on a gentle slope.  
20872  
PD15, 25, and 35 Storage Stand Assembly  
Figure 4  
Post HoleDigger Storage Stand Assembly Instructions Manual No. 317-189M  
 
10/06/08  
4
Land Pride  
Listing of Parts  
Kit No. 317-142A  
PD15, PD25 & PD35 Storage Stand Assembly  
Item  
Part No.  
Part Description  
Qty  
1
2
3
4
5
6
7
8
317-142A  
317-143H  
317-144H  
317-148H  
317-153B  
802-034C  
803-147C  
804-015C  
804-016C  
817-455C  
838-298C  
PD15, PD25 & PD35 STAND ASSEMBLY  
PD STAND HITCH WELDMENT  
PD STAND CRADLE WELDMENT  
PD STAND HITCH WELDMENT  
PD STAND HARDWARE BAG  
HHCS 1/2-13X1 1/4 GR5  
NUT HEX NYLOCK 1/2-13  
WASHER LOCK SPRING 1/2 PLT  
WASHER LFAT 1/2 SAE PLT  
1
1
2
1
4
2
2
2
2
2
9
10  
11  
KNOB 1/2-13 MALE THD 2 3/8OD  
DECAL CAUTION DO NOT LEAN ON  
10/06/08  
Post Hole Digger Storage Stand Assembly Instructions Manual No. 317-189M  
 
5
 
Corporate Office: P.O. Box 5060  
Salina, Kansas 67402-5060 USA  
 

Lanier Printer Accessories M1D User Manual
Leviton Telephone LE 47609EMP User Manual
LG Electronics Cell Phone VX8000 User Manual
LG Electronics Refrigerator LMU240HE User Manual
Linksys Network Router AE1000 User Manual
Marantz Blu ray Player 541110333221M User Manual
Maxxsonics Stereo Amplifier MLX 100 User Manual
Melissa Blender 646081 User Manual
Memorex TV DVD Combo MVUC821 User Manual
Meridian Audio Speaker M60C User Manual